HTMC-7 220V Automatic Egg Incubator Controller

Setting parameters temperature and humidity

1. Test: After connecting the components as shown in the figure, turn on the power, you will hear the alarm sound caused by temperature and humidity, and manually cancel the alarm.
   
2. Set the temperature and humidity, change the number of hatching days: Press the Set button, press "+/-" to select the desired temperature, set the humidity and hatching days in the same operation (repeat twice ) and finally hit the settings to exit the settings. (Note: The factory setting is 37.8 ° C, you can set 37.6 ° C according to the above method. After setting the hatching days, the machine reboots.)
   
3. Low or high temperature alarm parameter setting: Press the setting button for 3 seconds, press "+/-", the screen will display "AL", then press the setting button, press "+/-" to select the low temperature parameter. Press the setting button for 3 seconds, the display shows "AH", and the high temperature alarm parameter is set as above.
   
4. Humidity alarm parameter setting: humidity parameter is set to 45% when done and does not need reset. (If you need to set it according to the temperature parameter setting mode, the display shows "AS").
   
5. Temperature sensor report calibration: Normal temperature report is set to 0 ° C. If not correct, it can be set. The method is the same as above, and the display shows "CA".)
   
6. To set upper or lower limit temperature: if the HS (upper limit set) is set to 38.2 and LS (lower limit set ) is 37.4, the original temperature can only be changed from 38.2 to 37.4, and the lower limit should be 37.2.
   
7. Heating Element Configuration: HU and HD parameters are factory set and no reset is required.