Ublox Neo-M8N GPS For Pixhawk

A new generation Ublox GPS NEO-M8N with low power consumption and high precision, the ultimate accuracy is 0.6 meters, exceeding the previous generation's NEO-7N 1.4-1.6 meter accuracy. Supports GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol and mode.

GPS chip parameters:
Receiver type: 72-channel u-blox M8 engine
GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
SBAS L1 C/A: WAAS, EGNOS, MSAS
Galileo-ready E1B/C (NEO-M8N)
Nav. update rate1 Single GNSS: Up to 18 HZ
Concurrent GNSS: Up to 10 Hz
Position accuracy 2.0 m CEP
Acquisition2 Cold starts: 26 s
Aided starts: 2 s
Reacquisition: 1.5 s
Sensitivity2 Tracking & Nav: –167 dBm
Cold starts: –148 dBm
Hot starts: –156 dBm
Assistance AssistNow GNSS Online
AssistNow GNSS Offline (up to 35 days)
AssistNow Autonomous (up to 6 days)
OMA SUPL & 3GPP compliant
Oscillator TCXO (NEO-M8N/Q),
Crystal (NEO-M8M)
RTC crystal built-in
Noise figure on-chip LNA (NEO-M8M). Extra LNA for
lowest noise figure (NEO-M8N/Q)
Anti-jamming active CW detection and removal. Extra
onboard SAW band pass filter (NEO-M8N/Q)
Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N)
Supported antennas active and passive
Odometer travelled distance
Data-logger for position, velocity, and time (NEO-M8N)
Operating temp. –40° C to 85° C
Storage temp. –40° C to 85° C (NEO-M8N/Q)
–40° C to 105° C (NEO-M8M)
RoHS compliant (lead-free)
Qualification according to ISO 16750
Manufactured and fully tested in ISO/TS 16949 certified production sites
Uses u-blox M8 chips qualified according to AEC-Q100

Supply voltage 1.65 V to 3.6 V (NEO-M8M)
2.7 V to 3.6 V (NEO-M8N/Q)
Power consumption4 23 mA @ 3.0 V (continuous)
5 mA @ 3.0 V Power Save Mode
(1 Hz, GPS mode only)
Backup supply 1.4 to 3.6 V

NEO-M8N-0 u-blox M8 concurrent GNSS LCC module,
TCXO, flash, SAW, LNA,
Timepulse configurable 0.25 Hz to 10 MHz

Package including:

- 1 x NEO-M8N GPS module with translucent shell


Note: The M8N GPS firmware is fixed , so there is no need to revise firmware after receiving. 

Showcase