Official Raspberry pi Zero Case

The Raspberry Pi Zero Case has been designed to fit both the Pi Zero and the Pi Zero W. These official cases consist of several parts and protect the Raspberry Pi Zero from things like rogue wires that might short it out while still allowing full access to the board. Simply snap the RPi into the bottom half of the enclosure, then snap on a desired top. No tools required!

Each case has a standard base featuring a cut-out to allow access to the GPIO, and a choice of three lids: a standard lid, a GPIO lid (allowing access to the GPIO pins from above) and a camera lid (which, when used with the short camera cable supplied, allows the Raspberry Pi camera to be fitted neatly inside it). Additionally, each case includes a 4cm long CSI cable and four rubber feet.

Features

• This is a protective case specifically designed for the Raspberry Pi Zero and Zero W.
• The case consists of two parts. It has a standard base featuring a cut-out to allow access to the GPIO, and a choice of three lids: a plain lid, a GPIO lid, and a camera lid.
• It provides tough protection for the Raspberry Pi Zero/Zero W while providing access to all the connectors.
• It comes with a short camera cable and four rubber feet.

Kit Content

• 1 × Base
• 3 × Lids (Plain, GPIO, Camera)
• 1 × Short camera cable
• 4 × Rubber feet