Strain Gauge Trainer - Order Code 52003A

1. To get the good performance from the Tutor you have to maintain room temperature.
2. To check the power source, it should be 230V /-10%, 50 Hz.  to avoid over voltage hazards.
3. To get best performance, you have to put the instrument at dust proof and humidity free environment.
4. Do not try to open the instrument or repair it.  Contact manufacturer in case of any fault/difficulty.

1. Use of Strain Gauge for Weight measurement

1. Weight Apply : 600 Gm
2. Strain : 600 ms
3. Resolution : 1 ms
4. Excitation : 5 Volt DC
5. Power source : 230 V /- 10%, 50 Hz 

1. Display : 3-1/2 digit LED
2. Inputs : Strain Cantilever Beam full bridge
3. Cal : On pushing the red switch you will observe the adjusted calibration on the display.  The present Calibration adjustment is 199
4. Zero pot : Provided for zero adjustment 
5. Span pot : Provided for calibration.
6. ON/OFF switch : To ON/OFF the system.,
7. Fuse : 0.5 milliamps.
8. Light LED : Indicates the power supply when the when is in 'ON' position.
9. Test point : Excitation supply
• Red : E
• Green : E-                         
• Excitation : 5V fixed.
• Signals :
• Yellow : I
• Black : I-

for Product Catalog click below
Download PDF