EMax

2-6s 4 In1 40A BLHeli_S ESC Dshot 300-600

(No reviews yet) Write a Review

SKU:: PEBLH43
UPC:
MPN:
Condition:: New
Shipping:: Calculated at Checkout

KES4,200.00

Current Stock:

Quantity:

Frequently bought together:

Description
0 Reviews

Description

Description

Supply voltage: 2S-6S
Continuous current: 40A
Weight: 11.8 grams
Dshot150 Dshot300 Dshot600 support.
The Dshot series calls BB21MCU. 48Mhz
Support 2S-6S, 4PWM input without BEC
Support for Oneshot / Multishot / Dshot BLHELI-S firmware
Size 36mm * 36mm (standard 30.5mm Mounting Spacing)

Dshot vs Oneshot and multishot:

Dshot is purely digital signal, Oneshot and multishot are analog signals. During using analog signals, ESC hardware and software will make some noise, which is messy. If there is too much clutter, you need to add additional filter capacitors or filter hardware resistors. (Off topic, those needing to remove the capacitor is probably the case) and Dshot is a digital signal, no need for ESC calibration, no filtering is needed during transmission! After all, 0 is 0, 1 is 1, there is no distortion and no confusion; and it is very safe with a redundant check bit cycle (CRC).

Advantages of Dshot:

1. It is no longer required to calibrate ESC throttle stroke.

2. Accurate ESC signal is the biggest advantage of digital signal. PWM is an analog signal that is susceptible to wave distortion during transmission.

3. Compared with the present value of "1000 ~ 2000", the trip of the Dshot is "0 ~ 2048".

4. the speed above, faster than Oneshot ESC protocol.

5. security, Dshot comes with 4-bit Cyclic Redundancy CHECK (CRC).

Soldering:

The capacitors are in turn soldered to distribute the positive and negative boards of the ESC. Long legs are positive and short legs are negative.

Note: Please pay attention to the positive and negative of the capacitor, and you cannot reverse it, otherwise the consequences will be serious.

Package includes:

1 x 40A 4in1 ESC board