Breadboard kit

(1 review) Write a Review
0.13 KGS
Calculated at Checkout
  • Breadboard kit
  • Breadboard kit
Frequently bought together:



MB-102 quality bread board circuit board breadboard board universal board 165 × 55 × 10mm
• One terminal strip: 630 jacks
Weight 89g / month
• Two distribution strips: 200 jacks
• Product dimensions: 5.6x16.5x0.85 (cm)
• Phosphor bronze nickel-plated spring clip
• Matching jumper, wire diameter 0.8mm
• Plastic parts: ABS
• Use: experiment, test
recyclable, environmentally friendly recycling
The structure is clear and easy to use
Breadboard dedicated power supply module:
  • The breadboard can be assembled in fixed units
  • Breadboard dedicated power supply module, compatible with 5V, 3.3V   Applicable to MB102 breadboard
  • Input voltage: 6.5-12V (DC) or USB powered
  • Output voltage: 3.3V, 5V switchable
  • Maximum output current: <700ma 
  • Up and down two independent control, can switch to 0V, 3.3V, 5V
  • Onboard two 3.3V, 5V DC output pins


65 Root Breadboard Cables:

 Bread line / breadboard line Bread board connection cable Bundle board line tie a tie 65 (there may be 1-2 of the error, please do not care about)

The total length of 65 test lines are:

  • 24CM (with needle part) 4 root
  • 20CM (with needle part) 4 root
  • 16CM (with needle part) 8 root
  • 12CM (with needle part) 49 root
1PCS 65 Root Breadboard Cables
1PCS MB-102 Color breadboard
1PCS Breadboard power module


A breadboard is used to build and test circuits quickly before finalizing any circuit design. The breadboard has many holes into which circuit components like ICs and resistors can be inserted. The holes are most commonly spaced 0.1“ apart to accommodate standard DIP components. A typical breadboard that includes top and bottom power distribution rails is shown below:

Figure 1 Solder-less breadboard

The breadboard has strips of metal sockets which run underneath the board, yellow rectangles in figure 2, and connect the groups of five holes on the board. The metal strips are arranged as shown below. Note that the top and bottom rows of holes are connected horizontally while the holes in the center sections are connected vertically.

Figure 2 Arrangement of internal connections

To use the bread board, the leads of components are inserted into the holes. Each set of holes connected by a metal strip underneath forms a node. A node is a point in a circuit where two or more components are connected. Connections between different components are made by inserting their leads in a common node. The long top and bottom row of holes, indicated by the red and blue stripes are usually used for power supply connections. The rest of the circuit is built by inserting components and connecting them together with jumper wires. Solid rather than stranded wire is the best to use with breadboards like these.

ICs are placed in the middle of the board so that half of the leads are on one side of the middle line and half on the other.

View AllClose

1 Review

  • 5
    Breadboard kit

    Posted by Newton Kibiwot on 8th Jul 2020

    The best product, received as had been ordered. Value achieved

View AllClose